BUGATTI: DRILLING/INSTALLING GAUGES IN VENEER DASH
Today Geoff is going to show us his progress on the door window moldings then drill the dash facia to fit and install the gauges 🔥 https://www.hiltzautoco.com
#BADCHAD #HILTZAUTOCO #VENEER
Видео BUGATTI: DRILLING/INSTALLING GAUGES IN VENEER DASH канала Bad Chad
#BADCHAD #HILTZAUTOCO #VENEER
Видео BUGATTI: DRILLING/INSTALLING GAUGES IN VENEER DASH канала Bad Chad
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
CAME FOR A CHEVY T5 TRANSMISSION AND LEFT WITH A TRUCK LOAD1934 Bugatti Aérolithe - Jay Leno’s GarageTHIS CHOPPED 1948 FORD IS HERE TO GET WELDED BACK TOGETHERTHIS VINTAGE 1948 JC HIGGINS BICYCLE IS COOLER THAN DANGITCutting Board Hobby Turned Business OvernightHAULING HOME A 1947 FORD FLATHEAD V8 TRUCKTraded a snowmobile for an abandoned 1949 Pontiac with a stuck motor will it start?Can the County shut down TALLY HO?! / Sheer Planks (Rebuilding Tally Ho / EP92)INSTALLING THE 1967 JAGUAR 4.2L DOHC ENGINE 🔥PULLING THE HEAD ON THE '59 JAGUAR 3.4L ENGINEBugatti Chiron - Inside the Factory | Full DocumentaryBUGATTI: TESTING THE WHEEL TURNING RADIUS WITH MOCKED AIRBAG SUSPENSIONNeglected Forklift Finally Runs! | Area Diesel Service Saves my Bacon!FASTEST WAY TO SAND PRIMER FOR SHOW CAR FINISHModifying bear-claw door latches to fit handmade Bugatti doorsREMOVING BROKEN SPARK PLUGS FROM '59 JAG ENGINERepairing a failed rebuild and a second accident at the same time on this GMC TerrainRYAN'S CHOPPED 1948 FORD IS WELDED UP AND HEADED HOMEWatch Us Restore & Drive This 1967 Shelby GT-500 Mustang Barn Find - And Add Up Dollars Spent40 Years Later, Busted VW Bus Engine. Will It Run?