How to make RC Steam Launch (Wooden Hull 1.)

Let me share with you some photos from the steam ship model. It was a challenge. I never produced a wooden hull, so I first inspired myself on the Internet and I read a lot about it. PoTom I bought the material, mainly wood: plywood, lining to cover the fuselage and balm. From the plywood I cut the skeleton of the ship and the rib. Then I made the stool out of the board, and I put the hull on top of it. Until then I stuck the rib to the skeleton. This is because they are stuck at regular intervals. Then, the fuselage of the fuselage was followed. The feet were drenched in a warm voice, then bent slowly over the steam. I had to get sharper angles, so I added the burned bar to the burning body of the airplane. I started from the center of the trunk down. I was using the pins for the ribs and I glued them. It took a long time, but it did. Then I frightened and fought the fuselage. Laminating came to the table. The steam boiler is made of copper sheet with a thickness of 0.5mm. The glass is on the front in order to raise the level in the boiler. The bottom of the boiler is brazed on hard silver. the other joints are tinned. The liquid alcohol hopper has gone through several modifications until I found the right shape and the problem was with the wick as it is placed under the boiler horizontally. Lieh drifts to the knot by gravity. I wrapped the knot with a thin wire. This is how I got rid of witches. I bought the steam engine on the Internet, and I built an oil canister that pulls the machine running. Behind the machine is a small condensing vessel and then there is only a chimney :) And finally I fired the hull and added fewer accessories than bumpers which I also embroidered :) Boat I tried and you can see it on my canal. Thank you for looking at it. Bye
.

Видео How to make RC Steam Launch (Wooden Hull 1.) канала MySvestka