PM1228 Moving and Installation

The procedures and tools that I used to move the PM1228 lathe into my shop.

Warning: : I didn't notice it at the time, but looking at the setup now, the whole weight of the lathe is being supported by the smaller piece of Superstrut underneath the bed. Fortunately, it only has a short span between the ways. If the span were any longer, the Superstrut could easily bend into a V-shape with the point of the V where the bolt goes through. That could be a catastrophic failure. I should have used the thicker heavy-duty A-1200 Superstrut (the type I used for the upper cross-bar) for that cross-bar.

Видео PM1228 Moving and Installation канала Frank Hoose