DIY The Prancing Pony - LOTR

Who wouldn't want to visit the Prancing Pony a nice and non dangerous evening, for a chance to maybe meet a famous hobbit and have a pint of apple juice? 🍻✨
Things you need:

Template: Coming soon!
Reference photos
Wood base - I used plywood
Graphite paper or scribbled on the back of the template (for transferring the image onto the wood)
Hand saw
Freat saw or Coping saw
File and needle files
Ruler
Pen
Marker
Sculpting tools - metal, silicone
Air drying clay
Plasticard*
Scalpel
Scissor
Cutting board
Sandpaper och Dremel with a sanding drum with a fine sanding paper
Wood glue
Masking tape (painters tape)
Spray filler or primer
Respirator
Safety glasses
Ear protection
Paper glue (non permanent, you want it to be easy to remove with water)
Acrylic spray paint
Varnish - Satin, use a few layers if the sign is going to be hanging outside
Screw Eye
Model drill + small drillbits
Pliers - nipper, flat, (half round/flat)Metal rings or thicker meal wire
Screwdriver
Dremel - I’m using the Multipurpose Cutting Kit 565, Sanding Drum with a fine grit Sanding Band
Lamp chains
I’m using a cast iron flower hanger/bracket as a ”holder”

———————————————————————————————

If you want you can support my channel on Patreon: https://www.patreon.com/TheCraftMaiden

———————————————————————————————
Instagram: https://www.instagram.com/thecraftmaiden/
Facebook: https://www.facebook.com/thecraftmaiden/
Tumblr: https://thecraftmaiden.tumblr.com
DeviantArt: https://thecraftmaiden.deviantart.com
Pinterest: https://se.pinterest.com/thecraftmaiden/
Twitter: https://www.twitter.com/TheCraftMaiden
———————————————————————————————
*What is plasticard?

Plasticard is a hard plastic, it's industrial name is High Impact Polystyrene Sheet . UK modellers know it as plasticard, in the US it is commonly referred to as styrene sheet, plastcard or plastic card.

How do I cut plasticard?

For the very thin sheets, cut right through with a sharp craft knife or scalpel. Thinner sheets can also be cut with scissors. Otherwise the easiest way to cut styrene is by scoring it with a sharp modelling knife or scalpel, then bend it along the score, it should break cleanly. There will be a raised edge along the score line, this edge will clean up with a fine abrasive, file cards work well, or scrape it with the knife blade.

What glues do I use?

Polystyrene cement or any of the solvents or specialist glues that are used for the assembly of plastic kits. Don't forget to be in a well ventilated area, cause this make you dizzy otherwise..

https://www.stationroadbaseboards.co.uk/z_faq-plasticard.htm
———————————————————————————————

Music: Deep Hat by Vibe Tracks
Overdrive by Corbyn Kites
Etherial Choir Ascends by Doug Maxwell/Media Right Productions
✨”It comes in pints?!” - Pippin✨

Видео DIY The Prancing Pony - LOTR канала TheCraftMaiden