How to replace the Output Shaft Seal on a T10 Transmission

I recently developed a leak at the output shaft seal on my Borg Warner T10, side-loader, 4-speed transmission. This is an incredibly easy seal to replace as you basically only need a 1/2" wrench, screw driver, and a hammer. Jacking up the rear of the car to make all the transmission fluid move forward in the Trans also helps with the mess, or lack of a mess. I had a little difficulty finding the seal I need, but in the end I think the one I found will work great!

Seal used: O'Reillys Auto Parts, # 7692S, with a 2.375" OD and 1.43" ID (even though it says 1.5" ID in specs).
The car is a 1966 Mustang Coupe with a factory V8 and 4 speed transmission.

Shot with GoPro Hero 8 with the Media Mod, edited on Davinci Resolve 16.

Credit for the music in the video:
::::::::::::::::::::
Epidemic Sound
Try it today! https://www.epidemicsound.com/referral/f0tge1/
::::::::::::::::::::

#Mustang
#1966

Видео How to replace the Output Shaft Seal on a T10 Transmission канала Andy Kruse