LED Rear Turn Signal Install & Fender Mod: 2018 Ninja 1000 / Z1000SX

For more content, check out my new Instagram: jonlong724

In this video, I'll show you how to install aftermarket rear turn signals. I also show a simple modification to the rear fender for a more compact look. Stay tuned till the end to see a comparison between the stock lighting and the upgraded lighting.

How-To Remove and Install the Rear Fender: https://youtu.be/xK01tC6LyuI

Important Note: (This only applies if you are modifying the wires on your stock signals, which I was doing to add a connection for my integrated tail light) Slide the hardware (adapter plates, washer, nut, and rubber boot) onto the wiring BEFORE you start adding additional connections. The additional connections can make it hard or impossible to slide the hardware on.

Here are the products that I used:

License plate LED replacement:
http://a.co/2wHPSki

Rizoma Action LED Turn Signal (These come as single units. You need to order two to get a pair):
https://www.revzilla.com/motorcycle/rizoma-action-turn-signal

Rizoma FR415 Turn Signal Adapter Plate (requires very slight modification):
https://www.revzilla.com/motorcycle/rizoma-turn-signal-adapters-kawasaki

CustomLED Turn Signal Connectors/Adapters:
https://www.customled.com/products/kawasaki-oem-turn-signal-connectors-2-wire

CustomLED Blaster-X Tail Light:
https://www.customled.com/products/2011-2012-2013-2014-2015-2016-2017-2018-kawasaki-ninja-1000-integrated-led-tail-light

Bullet connector crimp tool:
http://a.co/hJEBMmN

Видео LED Rear Turn Signal Install & Fender Mod: 2018 Ninja 1000 / Z1000SX канала Jonathan Long