xTool F2 - New Material? No Testing Room? NO PROBLEM - done in 3 minutes! #laserengraving #xtoolf2

I was asked how I handle material engraving when I cannot run a test grid. Here's how: start FAST and remember the golden rule that you can't undo whatever you do.

I use a high speed and high power to determine the ease of getting into the material. Then, I slow it down by about half and repeat.

This set was done so quickly because I'm using the xTool F2. Get yours (ad): https://xtool.pxf.io/Z6ZLG1

Check Out My Favorite Supplies: https://amazon.com/shop/rufflesandrain

Let's Stay in Touch:
📩 Sign Up for My Free Newsletter: https://rufflesandrainboots.myflodesk.com/general-sign-up
📘 Facebook Group: https://www.facebook.com/groups/diygnomesandcrafts
➡️ Follow on Facebook: https://facebook.com/rufflesandrainboots

Mailing Address:
Sarah Nenni-Daher, Ruffles and Rain Boots
PO Box 653
Leander TX 78646

As an Amazon Associate, I could earn from qualifying purchases. There could be affiliate links within this description and shared in videos.

Видео xTool F2 - New Material? No Testing Room? NO PROBLEM - done in 3 minutes! #laserengraving #xtoolf2 канала Sarah Nenni-Daher