DIY Misti A4 formaat

Gemaakt door Fay & Kitty

Zie de ondertiteling aan voor uitleg!
DIY Misti in A4 formaat gemaakt met een acryl plaat, karton, lijmpistool en 3 scharnieren.

English directions:
Measurements of the accrilic plate 50x33 cm
Cut the plate in ahlf at 25 cm. I used a special blade to cut it.
A piece of cardboard 3mm thick and 33x25 cm. Draw the placement of the hinges on the cardboard.
Measure 1,5 cm at both sides and at the side of the hinges 3,5. This will be the edge where you put your paper you will be stamping against so it doesn’t move.
Than you cut where you drew the placement of the hinges so you get a gap you can glue your hinges in.
Draw a line where you measured 3,5 cm at the side of the hinges. At the other side where you measured 1,5 cm you do the same. Then you can cut at the lines so your left with a frame when you’re finished. My cardboard is 3mm thick. If you don’t have cardboard that thick you can glue two thinner pieces together.
Important is to see if the hinges fit in the gap you cut previously.
Now you can glue the cardboard frame you cut on one piece of the acrylic plate. Put the glue on the cardboard using a hot glue gun. Then you place it on the acrylic frame. Make sure both pieces line up evenly. Press it firmly.
Now you can glue your hinges to the acrylic plate. Its best to do this one at a time all open and facing in the same direction. And press firmly.
Cut pieces of thin cardstock or paper to put inside of the hinges and then shut them. This is to prevent you from glueing the hinges shut.
No you can glue the other plate to the hinges. Put enough glue on all of the hinges. And put the acrylic plate on top. Line the plate up with the other plate and press firmly.
Now you can remove the pieces of cardboard inside the hinges, and also remove the foil of the acrylic plates.
I put washi tape on the cardboard and on the outside of the acrylic plate so it looks more fun and hides the hinges.
Done!! Now you can use it!

Видео DIY Misti A4 formaat канала Fay Lommen