Trick Tutorial: How to do Dirty Rolls and Flairs | Mode 4 FPV Freestyle

Mode 2 and 3 guys bear with me for a sec. Despite me using Mode 4 controls here, these tricks are simple enough that Mode 2 or 3 pilots should have no issue learning. Just some tricks to store in your tool box to pull out to keep your flights fresh.

Also yeah that was broken switch if you caught that. :p

#goonskwad #ethix #freestyle
++++++++++++++++++++++++++++++++++++++++++++
MyFPVStore.com sponsored pilot.
-------------------------------------------------------
All links are up to date. Gear listed here can be found in my quads and is the gear I use to have a fun, quality experience.

--5inch Kwad Setup- -
Frame:
-Armattan Marmotte https://bit.ly/2Ur6fNH
Flight Controller:
-Flyduino KISS v2 32bit https://bit.ly/2GLAYSX
ESC:
-Flyduino KISS 32A 32bit https://bit.ly/2O2xAEh
Power Board:
IMPULSERC WOLF PDB https://bit.ly/2GILEBX
Motors:
-Mr. Steele Silk v2 2306 2345kv https://bit.ly/2S5LJ8W
Props:
-HQProp Ethix S3 5x3.1x3 https://bit.ly/2MPiYHw
Camera:
-Runcam Micro Eagle https://bit.ly/2S6WTu4
Receiver:
-Crossfire Nano https://bit.ly/2Db08Gn
Receiver Antennas:
-Standard https://bit.ly/2t4T3Td
-Immortal T https://bit.ly/2DRakpl
VTX:
-TBS Unify Pro HV https://bit.ly/2DbjZWi
VTX Antenna:
-TBS Triumph https://bit.ly/2Ttefhp
Battery:
-RDQ 1300 4S https://bit.ly/2S4Nvap
Battery Straps:
-ETHIX GoPro Strap https://bit.ly/2WzaWHv

--10inch Kwad Setup--
Frame:
-Nasty405 10inch https://bit.ly/2G9u9dS
Flight Controller:
-BrainFPV Radix https://bit.ly/2p2wiOf
-Radix PB https://bit.ly/2DftykV
ESC:
-Airbot Wraith Metal V2 66A ESCs w/ 50v 1000uf low ESR caps. https://bit.ly/2HORBi7
Battery:
-Pyrodrone Graphene 2200 5S https://bit.ly/2t6lXm5
Motors:
-BrotherHobby Tornado T5 3115 1050kv motors w/ HQ 9x5x3 Prototypes
VTX:
TBS Unify Pro V3 https://bit.ly/2RzQaUs
Antenna:
-TBS Triumph https://bit.ly/2Ttefhp
RX:
-Crossfire Nano https://bit.ly/2Db08Gn
-w/ SMA pigtail running to a Crossfire tuned TX antenna.
Camera:
-Runcam Eagle Micro https://bit.ly/2S6WTu4
-M8N UBLOX GPS
-3D printed rear dual SMA mount and GPS mount by @danimal_fpv.

--Gear--
Radio:
-FRSKY QX7S https://bit.ly/2REatjw
Long Range:
-TBS Crossfire Micro Module https://bit.ly/2MNDGYl
Goggles:
-FatShark HDO
Goggle Receiver:
-ImmersionRC Rapid Fire https://bit.ly/2TsU3vX
Antennas:
-VAS Mad Mushroom v2 https://bit.ly/2HNHhHi
-VAS Crosshair XTREME (Better than what I use) https://bit.ly/2RDy1oy

Other Gear:
-Gopro Session 5
-GoPro Session 4
-Neck Strap: https://bit.ly/2t0NYLK
-Soldering Iron https://bit.ly/2HMuxjR
-Soldering Iron Carry Case: https://bit.ly/2HMBMsh
-BetaFlight Hive Backpack

Видео Trick Tutorial: How to do Dirty Rolls and Flairs | Mode 4 FPV Freestyle канала Red5 FPV