“Drop Zone” Entry Storage Cubbies, Bench, & Coat Hooks: EASY DIY Project How-To Build and Install!

Thank you for checking in! Perfect DIY project for the entry of your home! Shoe cubbies, bench seat and coat hooks to help organize walking into the house. Full step by step instructions that YOU can understand! ENJOY!

00:00 | INTRO, Going Over Material
01:19 | Measuring the Opening, Cutting the Bottom Cubbies
04:33 | Build and Install Bottom Cubbies
09:10 | Top / Facing Bottom Cubbies
12:28 | Coat Cubby with 1/4” Bead Board Backer
15:56 | Facing and Fully Installing Coat Cubby
21:27 | Wood Fill and SAND!
22:57 | Thank You, Please Subscribe

********PLEASE NOTE********
I am a professional at using these tools. Please use the proper safety equipment for each tool and refer to the manual for operating instructions!

TOOLS USED:

OCCIDENTAL LEATHER Tool Bag - https://amzn.to/3q8YBJy
TAPE MEASURE SUSPENDERS - https://amzn.to/30GwjgO
STANLEY 25ft. FatMax Tape Measure - https://amzn.to/3yHzqSi
DEWALT 12-inch Miter Saw - https://amzn.to/3J6FnwL
DEWALT Miter Saw Stand - https://amzn.to/3sk2gXC
DEWALT Atomic 20V Max Circular Saw - https://amzn.to/3J3QwyE
METABO 16Ga Finish Nailer - https://amzn.to/3e9dFkJ
METABO 18Ga Finish Nailer - https://amzn.to/3J715RA
STABILA Levels 6pc. w/ Nylon Case - https://amzn.to/32fIBNB
PORTER CABLE Air Compressor - https://amzn.to/30HKF0x
WOOD SHIMS - https://amzn.to/3yFOjEy
TITEBOND Wood Glue - https://amzn.to/3yGiyLH

MATERIALS USED:

- 1 X 16 MDF 16 ft
- 1 X 6 MDF 16 ft
- 1 X 4 MDF 16 ft
- 1 X 2 MDF 16 ft
- 4 ft X 8 ft X 1/4” Bead Board (Alpine Lumber)
This bulit-in is featured in a lot of DR Horton homes across the country. It is a simple design meant for organizing your shoes, jackets and other belongings as you enter your home. Sometimes it can be located in a mudroom entering from the back of the house, but for most floorpans for DR Horton, it is located close to the door entering into the house from your garage. I feel this is a perfect DIY project for homeowners with some tool skills, but at the very least I HOPE this gives you an idea for what you envision in your home!

For this “drop zone” all you need to know is the width of your base bench/cubbies and just a little math to figure it out from there! For my application I did not need to worry about the depth so maybe verify that you are happy with 16” of depth for your base. You can also build the base with 1 X 12 MDF if you need to shrink it down a bit!

Any questions please let me know!

Special Thanks:

Bryan - For keeping us moving and all the ideas to help our futures!

Youtube Copyright free music

Видео “Drop Zone” Entry Storage Cubbies, Bench, & Coat Hooks: EASY DIY Project How-To Build and Install! канала Hunter Carlson