Spline Milling a Clutch Input Shaft for a Porsche Dynamometer Single Point Boring Bar Cuts Profile
In this video I do a bunch of spline milling for some shafting used to setup and dyno some Porsche and VW engines. The splines were 24 and not involute so I ground a lathe tool slightly to match the taper of the side of the splines based off the original shaft sample. It was a whole lot of indexing and I am sure glad I didn't mess it up as it is super easy to loose track of what you are doing when using those dividing heads. I hope you enjoy seeing it done and Thanks for Watching!
Видео Spline Milling a Clutch Input Shaft for a Porsche Dynamometer Single Point Boring Bar Cuts Profile канала bcbloc02
Видео Spline Milling a Clutch Input Shaft for a Porsche Dynamometer Single Point Boring Bar Cuts Profile канала bcbloc02
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
First Gen Intercooled Dodge Cummins VE Dyno Proven 400rwhp and 1000ft-lbs tq Recipe for under $4kBig Block Deere cylinder Head reconditioning Plus new to me Parts Washer debut!Cutting Cylinder Liners for Fire RingsThis Old Barn/ Shop concrete prep.... Finally!!Newall DRO Won't Power Up FixCummins Swap the Hyster Rc150 Forklift Part 17This Old Barn/Shop Concrete Pour #2Fixing the Power Raise and Lower on the G&L340TOctober 2017 This Old Barn/Shop UpdateCylinder Head AssemblyI Bought a Semi Truck Chassis Dynamometer ! Taylor CM-51 1100 continuous hp @ 80-90MphThis Old Barn/Shop first concrete!Diesel Tractor Pulling/Racing PartsGanging Parts to Save TimeDodge Cummins First Gen A1 Head Studs and 7x.011 Injector Install Big Trailer Towing Power 400hp?Shop update and crane and drill repair donations as well as PatreonCummins Hyster Part12: Engine FittingMay This Old Barn/Shop update and a visitorMid August this Old Barn/Shop updateHow I setup Parts with Damaged Features Align Boring Blind Hole Using Rotary TableApril 2019 This Old Barn/Shop Update