MOTORIZED DRIFT TRIKE HOME BUILD PROJECT.

We made this drift trike over the Christmas holiday just to see if pipe bender is capable of making different types of bends. Its very limited to what it can do but its good enough for us.

Here's a measurements description of this frame.
Two main pipes that makes up the frame is 65 inches long(165cm)
They were bent 130°degrees at 25 inch mark (64cm)
Foot rests or pegs are 20 inches long (50cm) and were bent 130° degrees at 7 inch(18cm) mark.
Seat support or seat rest pipes are 20 inches each(50cm) and they are bent 90° degrees at 4 inch(10cm) mark. Then they are welded together to form that type of form. Rear handle is made the same way but the length is up to you. Two ears or axle supports are 30 inches long(76cm) and are bent 130° degrees at 10 inch(26cm) mark on each side. All measurements are approximate and can be modified to fit the persons height and length during the build process.
Размеры рамы приблизительно потому что я мерил в дюймах но в см почти точно. Две главные трубы (160см каждая) и согнуты они под 130 градусов на метке 60см. (Между 60см и 100см)
Подножки для ног 50см каждая и согнуты на метке 16см под 130 градусов. Длина трубы которая является опорой для сидения 48см каждая а потом они сварены вместе. Изгиб под 90 градусов на метке 8см. Два уха на которых держится задняя ось с подшипниками 80см. Два изгиба по 130 градусов с каждой стороны на метке 26см.

Видео MOTORIZED DRIFT TRIKE HOME BUILD PROJECT. канала balabay77