GX4 Carry Magazine Improvement - Custom 3D Printed Upgrade (Made in Texas)

This is a custom 3D-printed baseplate and sleeve set for the Taurus GX4 Carry magazine.

https://ebay.us/m/K7F0sC - ABS CF 2 Sets + Free Speedloader
https://ebay.us/m/SUEE4p - Nylon CF 2 Sets + Free Speedloader

As much as I appreciate the GX4 Carry’s compact and modern design, one detail always stood out to me: the factory magazine baseplate leaves an exposed gap at the rear of the grip — a spot that feels unfinished and out of sync with the rest of the pistol.

Using 3D modeling, patience, and a lot of testing, I created a two-piece solution:

A baseplate that holds the magazine spring securely

A sleeve that completes the grip profile and enhances the aesthetics

This modification keeps the original grip length (it does not extend it),
but adds visual balance and a much better pinky support — especially helpful for those with larger hands.
The rounded corners also improve comfort during concealed carry, removing sharp angles that can dig into your side.

The set is printed in high-quality ABS-Cf and Nylon-CF tested for strength and fit, and produced here in Texas, USA.
00:00 Safety
00:40 GX4 Carry Design
01:00 Missing Part of the Magazine
02:00 The new Baseplate and Sleeve
03:06 Installation / Replace OEM Baseplate
03:35 New Look
06:51 Disclaimer

#taurusgx4
#GX4Carry
#3DPrintedUpgrade
#taurusgx4
#3dprinting
#edc
#gunmods
#3dprinting
#gx4carry
#taurus

Видео GX4 Carry Magazine Improvement - Custom 3D Printed Upgrade (Made in Texas) канала iceman_GA