Casting DIY Skateboard Trucks At Home - Ep. 3
In this video I cast a set of skateboard trucks in my garage. I use green sand to make the molds and 3d printing to make my bucks and some other tools to get my parting lines the way I want them. The aluminum is from some old router housings and the axles are steel setup studs. I'm stoked on how these came out!
Rounding your deck’s rails is a breeze with the Bishop router mount:
https://www.goodroadscollective.com/shop/p/bishop-edge-rounding-jig
Drill perfect bolt holes with the Scarab drilling guide:
https://www.goodroadscollective.com/shop/p/scarab-ii-bolt-hole-drilling-guide
Want to support the channel? Check out the Patreon:
https://www.patreon.com/goodroads
Or grab yourself something from the shop:
https://www.goodroadscollective.com/shop
IG: @chrisfromgoodroads
Tunes by Drew McCann:
https://drewmccann.bandcamp.com/
Видео Casting DIY Skateboard Trucks At Home - Ep. 3 канала Good Roads
Rounding your deck’s rails is a breeze with the Bishop router mount:
https://www.goodroadscollective.com/shop/p/bishop-edge-rounding-jig
Drill perfect bolt holes with the Scarab drilling guide:
https://www.goodroadscollective.com/shop/p/scarab-ii-bolt-hole-drilling-guide
Want to support the channel? Check out the Patreon:
https://www.patreon.com/goodroads
Or grab yourself something from the shop:
https://www.goodroadscollective.com/shop
IG: @chrisfromgoodroads
Tunes by Drew McCann:
https://drewmccann.bandcamp.com/
Видео Casting DIY Skateboard Trucks At Home - Ep. 3 канала Good Roads
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала