EGC-TB (-HD): Replacing the toothed belt
Replacing the toothed belt on Festo axis EGC – this tutorial explains how it's done.
Repair your Festo products quickly and easily with videos from service2see!
00:00 Remove the clamping component
02:50 Remove the drive cover
03:50 Replace the toothed belt
05:14 Assemble the clamping component
08:10 Reinstall the drive cover
09:40 Reinstall the clamping component
10:53 Check pre-tensioning of the toothed belt
Видео EGC-TB (-HD): Replacing the toothed belt канала Festo Service
Repair your Festo products quickly and easily with videos from service2see!
00:00 Remove the clamping component
02:50 Remove the drive cover
03:50 Replace the toothed belt
05:14 Assemble the clamping component
08:10 Reinstall the drive cover
09:40 Reinstall the clamping component
10:53 Check pre-tensioning of the toothed belt
Видео EGC-TB (-HD): Replacing the toothed belt канала Festo Service
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Festo Automation Suite: Projekte im Topologie-Editor bearbeitenFluidDraw P6: Displaying valve terminals1/4 CPX-AP-I-EP in Rockwell PLC via EtherNet/IP: Commissioning (electrical)MPA-L with PROFIBUS: Commissioning in the TIA portalMPA-L with PROFIBUS: Commissioning on Siemens S74/4 CPX-AP-I-EP an Rockwell SPS über EtherNet/IP: Funktionen von AOIs nutzenFluidDraw P6: Schläuche definieren und Schlauchlisten erstellenELGC: Abdeckband ersetzenSMS Simplified Motion Series mit CDSU-1: In Betrieb nehmenFesto Automation Suite: Traceaufzeichnungen anzeigenDHTG: Replacing the set of wearing parts (dynamic)ELCC: Replacing the cover stripFesto Automation Suite: Servoantriebregler CMMT-AS ins CODESYS-Programm einbindenYJKP WebVisu: Diagnose auswertenDAPS: Verschleißteile ersetzenFesto CMSH: Zustandsüberwachung und Diagnose nutzenMPA-S mit PROFINET: Inbetriebnahme im TIA-PortalFesto CMSH: Using monitoring and diagnostic functionsYJKP WebVisu: CommissioningHGPP: Replacing wearing partsFesto Automation Suite: Der Gerätescanbereich