Proma THC not working while cutting
Sorry bad video quality, and side ways... I recorded on iphone.
Please make any recommendations
video 1 of 2.
Video #2 shows all my setup screens from beginning to end and the problems I am having with the torch height control for Z axis.
I can get the Proma THC working in test mode, but not while cutting.
Mach3, sheet cam, 100PSI, 65 amps Hypertherm 85, 130 Volts, (all recommended settings from Hypertherm manual)
Видео Proma THC not working while cutting канала Matt Diederichs
Please make any recommendations
video 1 of 2.
Video #2 shows all my setup screens from beginning to end and the problems I am having with the torch height control for Z axis.
I can get the Proma THC working in test mode, but not while cutting.
Mach3, sheet cam, 100PSI, 65 amps Hypertherm 85, 130 Volts, (all recommended settings from Hypertherm manual)
Видео Proma THC not working while cutting канала Matt Diederichs
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Plasma CNC Proma THC install with Mach3thc mach 3 - how change "thc min" to negative valueCNC Plasma THC (Proma) working install with Mach3 & smooth stepperLangmuir systems Z-Axis Ports and Pins Tutorialสาธิตเซ็นเซอร์ตรวจจับวัตถุ จับสิ่งกีดขวาง Infrared photoelectric switch Sensor E18-D80NKMaking a Proma SD work🔴 CNC: ZERO MACCHINA E SISTEMA DI RIFERIMENTO 🔴Mach3 Turn EncoderPlasma Cutting - Height ControlMach 3 Has Never Looked This Good! (CNC Software Part 2) - S03E14Learn Arc Voltage Height Control on a CNC Plamsa Table with Jim Colt198 Mach3 configure, motor tuning, machine and soft limitsTroubleshooting in Mach3Proma SD vs 150 torch height controlConstruction d'une cnc PLASMA Ep 4 :THC arduinoSheetcam and Plasma CuttingProma THC150 settings for Masso PlasmaMach3 Motor Tuning - Upgrading Stepper Motor ProcedureTutorial cortador PLASMA CNC de 0 a 100Mach3 USB Controller Output Terminals