Chainsaw Repair Part 3

Carburetor TLC, assembling and attempt to start

0:03 My helping ragdoll kitten is working with me again
0:20 Opening fuel pump part
0:40 Wiping old oil and grease
2:00 How to remove fuel adjustment screws and place them back in same position later
2:40 Jet was definitely clogged
2:50 Disassembling float needle
3:20 Cat is supervising TLC process from the shrubs
3:40 Assembling float needle
4:40 Assembling carburetor back
4:50 Forgot to remove and clean up second valve screw.
5:10 Second jet is clogged too
5:30 Now assembling the carburetor
6:30 Cleaning gas tank
6:55 Quick exterior rinse for engine before assembly
7:40 Cleaning ignition coil
8:10 Installing carburetor back
9:10 Adjusting gap between flywheel and ignition coil
10:00 Cleaning the back cover
11:05 Darcy the little kitten is still hanging around
11:30 Placing engine into the back cover
11:50 Long and annoying trigger installation
15:50 Finally back cover installed
16:10 Can't connect gas hose with assembled cover. Disassembling back
17:00 Assembling again. Now it is faster, I got skills
20:35 Ready for test
21:50 Gas is leaking. Old gas hose is bad.
22:30 No luck to start. Need new gas line.

Will continue repair and replace gas line in next video. Hope it will start.

Видео Chainsaw Repair Part 3 канала Beaver's Hut