- Популярные видео
- Авто
- Видео-блоги
- ДТП, аварии
- Для маленьких
- Еда, напитки
- Животные
- Закон и право
- Знаменитости
- Игры
- Искусство
- Комедии
- Красота, мода
- Кулинария, рецепты
- Люди
- Мото
- Музыка
- Мультфильмы
- Наука, технологии
- Новости
- Образование
- Политика
- Праздники
- Приколы
- Природа
- Происшествия
- Путешествия
- Развлечения
- Ржач
- Семья
- Сериалы
- Спорт
- Стиль жизни
- ТВ передачи
- Танцы
- Технологии
- Товары
- Ужасы
- Фильмы
- Шоу-бизнес
- Юмор
500 HP for 5000€ Project car challenge under 10s 100-200 (60-130) | Introduction VR6 Turbo
#VR6 #turbo #projectcar #tuning
In this video im introducing my new project car. This is going to be a low budget project again and i want to see how fast we want to go with about 5000€. So can we reach 500 or more HP? can we go faster than 10 seconds from 100-200 KM/H all this and more we will show with this build
Ask me Anything on Instagram (Questions, Tuning Service, Build advice etc!):
https://www.instagram.com/_throttlebuddies/
Business inquiries: wtl.business.yt@gmail.com
Camera Gear:
Sony Alpha 7 (first Gen)
Meike 85mm F1.8 (Manual)
Sony Kit 24-70MM
Rode Smartlav with LC1
Rode Videomic
Видео 500 HP for 5000€ Project car challenge under 10s 100-200 (60-130) | Introduction VR6 Turbo канала Throttlebuddies
In this video im introducing my new project car. This is going to be a low budget project again and i want to see how fast we want to go with about 5000€. So can we reach 500 or more HP? can we go faster than 10 seconds from 100-200 KM/H all this and more we will show with this build
Ask me Anything on Instagram (Questions, Tuning Service, Build advice etc!):
https://www.instagram.com/_throttlebuddies/
Business inquiries: wtl.business.yt@gmail.com
Camera Gear:
Sony Alpha 7 (first Gen)
Meike 85mm F1.8 (Manual)
Sony Kit 24-70MM
Rode Smartlav with LC1
Rode Videomic
Видео 500 HP for 5000€ Project car challenge under 10s 100-200 (60-130) | Introduction VR6 Turbo канала Throttlebuddies
Комментарии отсутствуют
Информация о видео
16 ч. 21 мин. назад
00:01:56
Другие видео канала
What is the right Fuel Setup for your Turbo build? | Injectors, Fuel Pumps, adapters, compatibility
Closed and Open Loop: What does it mean? | Idle, boost and Fuel correction modes explained!
Put a Standalone ECU in ANY car! | What is needed and what to look out for!
Breaking in a Freshly Build /Rebuilt Engine | How-To / Guide | 4A-GE 20V Budget Engine Rebuild
Tunerstudio standalone ECU Tuning Guide | Part 18 Upgrading injectors (Turbo) | MS, Speeduino RUSEFI
Tunerstudio Standalone ECUTuning Guide | Part 8: Engine Safeties, Protections, limiters | Megasquirt
Rebuilt 4AGE 20V first startup | Low budget Engine rebuild #jdm #tuning #automobile
Toyota 4AGE 20V Silver Top | Sounds in the Mountains, RAW 8000 RPM
Prepping for first startup - hardware checks Ignition, injectors and sensors| RUSEFI Tuning Guide #6
Unser neues Projekt | Schon wieder ein MX-5? | Tracktool Projekt
Main bolts vs. Stufs & 12.9 SHOULD you upgrade?| When to use what | Build your bottom end right #1
Budget Turbo 4AGE 20V Build | Fabricating intercooler piping and first Test drive + Turbo sound
Huge turbo Miata final Test drive at low boost | Rowdy mountain drive at only 7 PSI
What is THE BEST standalone ECU for your build? | How to choose the right engine management!
Wie man Motoren (Nicht) Transportiert! 🤪 | Riesen Fail 5 Minuten nach Diff-Einbau 😬🤦♂️
Blew my engine in the most stupid way possible... | 4AGE 20V Turbo project blown engine before turbo
Drag Miata light weight racecar interior | Android Digital Dash mount | 1000 HP intercooler install
How to F**k your engine with this one simple trick.... and rebuild it in 5 days! | 4AGE Turbo Update
Mazda MX-5 NB 1.6 NA Build Tune analyzed | 110 to 130 HP NA with dyno | Rate my tune #2
Block braces Main Girdle and Billet main caps, When do you need it? | Build your bottom end right #2
3D Printed Velocity stacks for ITBs | First time 3D-printing car parts | Will PLA hold up?
