Luckily managed to remove broken bolt for crankshaft pulley
Hi,
this is lucky removal of broken bolt, so bolt was broken before as it looks like. Always try remove the bolt this way, saves you time and hassle, if not possible this way the small drill bit and than multispline socket or removal tool should be used.
Thanks for watching
share and subscribe
Видео Luckily managed to remove broken bolt for crankshaft pulley канала out_of_service
this is lucky removal of broken bolt, so bolt was broken before as it looks like. Always try remove the bolt this way, saves you time and hassle, if not possible this way the small drill bit and than multispline socket or removal tool should be used.
Thanks for watching
share and subscribe
Видео Luckily managed to remove broken bolt for crankshaft pulley канала out_of_service
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Engine oil and filter changeTest and repair of PTO engagement unit #ShortsHow to carry heavy gearboxCAN bus Bad signal vs. Good signal on Oscilloscope #ShortsEngine smokey on start, timing fault code set/ Testing engine timing/ found Timing advanced #ShortsABS light on dash / wheel speed sensor fault/ broken wire #shortsCheck for this on your starter motor/preventive maintenance/no-breakdowns #ShortsFuel injector seal replacement injector stuck using new toolMilwaukee impact driver and Makita Gold flexible/tilt socket adapter in actionPlasma cutter in action #shortsEGR clogged #ShortsBMW ZF 5 speed transmission/gearbox Shift detents replacementExhaust flexi pipe broken - engine sounds greatUnboxing new Turbocharger core #ShortsReplacing Common rail fuel pressure sensor-4°C Cold start #ShortsMilwaukee stubby impact gun making noise #ShortsHow to repair blower motor on carCamshaft lobe moving #ShortsReplacing Diff oil seal #Shorts