Загрузка страницы

Hammer K-3 Zero Clearance Inserts

This video is about the huge improvement of my shop made ZCI's over the factory issued ZCI's for the Hammer K-3 Winner sliding table saw. And I show how to safely cut (elongate) the kerf to accommodate the riving knife and an easy way to create the scoring blade kerf.

Zero Clearance Insert for the Hammer K-3 Winner; A quality made insert with plenty of support, including to the left of the blade: https://ramonvaldezfinefurniture.com/product/zero-clearance-insert-for-felder-hammer-k-3-winner/

See more at: http://ramonvaldezfinefurniture.com/

Tons of tips, tricks of the trade at my Instagram account: https://instagram.com/ramonartful

Couple of things to note: These ZCI's work best with a 10" blade (and scoring blade if equipped). It can be used with a 12" blade (no scoring) but with the addition of a riving knife, the slot or kerf is very long and will weaken the ZCI. Also, when cutting the kerf to start, make sure your scoring blade (if equipped) is low enough, or remove it entirely.

Видео Hammer K-3 Zero Clearance Inserts канала Ramon Valdez Fine Furniture
Показать
Комментарии отсутствуют
Введите заголовок:

Введите адрес ссылки:

Введите адрес видео с YouTube:

Зарегистрируйтесь или войдите с
Информация о видео
14 июня 2020 г. 5:31:09
00:15:28
Яндекс.Метрика