TFT 35 Custom Mount Installation to Creality CR10S-x
As part of an upgrade to my CR10-S5 I found the need to mount the BIGTREETECH TFT 35 outside of the stock enclosure to allow the SD card and Micro USB connectors to be accessible. If you own an Ender then likely this is not an issue for you...
The files for mount and all components needed are on thingiverse and I will supply a link below.
Thingiverse STL files: https://www.thingiverse.com/thing:6569596/files
Видео TFT 35 Custom Mount Installation to Creality CR10S-x канала kaydee457
The files for mount and all components needed are on thingiverse and I will supply a link below.
Thingiverse STL files: https://www.thingiverse.com/thing:6569596/files
Видео TFT 35 Custom Mount Installation to Creality CR10S-x канала kaydee457
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
X2 Mini Mill Conversion- Part 5a- Planning Installation of Electronics Components
HVAC:Pt.7b: 22-5 Ton to 410A-5 Ton- AIR HANDLER, Measure TESP (Total External Static Pressure)
DIY: Installing Crown Moulding- Part 11
Landscape Power Supply
reci tube test
Spit Retracts Redux
DIY: Installing Crown Moulding- Part 7
corsair retract done
2.x Laser Cut Example
DIY: Installing Crown Moulding- Part 3
Making the Pour
DIY: Installing Crown Moulding- Part 6
HVAC:Pt.8: 22-5 Ton to 410A-5 Ton-Connect Condenser electrical and piping
HVAC:Pt.4: 22-5Ton to 410A-5Ton-Remove old Heat Pump
HVAC:Pt.2: 22-5Ton to 410A-5Ton-Prelim Tests
Laser cutting
CR10-S5 dual Z axis synchronization upgrade/modification
Rear-end collision
HVAC:Pt.6: 22-5Ton to 410A-5Ton-Make resized Return Plenum
DIY: Installing Crown Moulding- Part 10