Building a Simple & Cheap 50-Ohm Dummy Load.

We always need a good 50-Ohm dummy load. Here is a cheap build using a Chinese 250W resistor from Ebay. I will later incorporate an RF probe, also mentioned here. The case is a Hammond 1550Q cast aluminum, which will not dissipate 250W. You would need a heat-sink for anything more than 30W probably... Resistor: Search for "RFP 250N50." Get more content and help this channel: https://www.patreon.com/radioprepper DISCLAIMER: The Radio Prepper logo (depicting a microphone) is indeed inspired from a famous flag created in 1775. It is NOTHING BUT a symbol of freedom and independence. It does NOT imply support to any political group. It does NOT imply, represent nor support any ideology with an intent on harming anyone. Freedom means freedom from persecution based on any human trait or belief such as, non exhaustively, race, gender, religion, sexual orientation or nationality. The Radio Prepper channel is a technology and science channel with a focus on preparedness and use of radio technology for disaster relief and small group communications in times of need. It is apolitical and open to anyone sharing the same interests. .
Subscribe to my alternate platforms:
https://ugetube.com/@RadioPrepper
https://odysee.com/@RadioPrepper:1 oops, wrong address! Correct one below:
https://odysee.com/@RadioPrepper:d
Now you can buy me a coffee :-) https://www.buymeacoffee.com/gilg .
Send Bitcoins to: bc1qc5jq4dxt7359sh80lkv9v8rlsgnh322hmn6xyc

Видео Building a Simple & Cheap 50-Ohm Dummy Load. канала Radio Prepper