S07E06 - Shimano Nexus - Broken shifter

Visit http://bikebook.si

Hello everyone. Today we are going to replace a broken shifter on Shimano Nexus 7 speed internal geared hub.
Lets start by removing the old broken shifter and cable.
Lube the end of the outer gear casing and place the protective end cap over it. This repels water.
Route the cable through the outer.
Turn the adjustment knob all the way in. Then turn it two turns back.
Set your shifter in fourth gear. Check the manual for specific instructions.
Pass the inner cable through the fixing bolt.
Use the allen key to turn the pulley into position for hooking the cable to it.
There are two yellow setting lines on the hub that you should closely line up when placing the fixing bolt on the cable. This is a bit of trial and error. Use the adjustment knob for fine adjustment. Don’t forget that you should be in fourth gear on the shifter.
When all done, cut the cable and squeeze on the protective cap.
You should watch our previous movie to find out why we use hair spray on rubber grips. Have a nice day and don’t forget to subscribe.

Видео S07E06 - Shimano Nexus - Broken shifter канала bikebook