#14 Wiring Voltage Dividers for Proximity Sensors #14 / CNC Control Box

In this video I add voltage dividers between the X, Y and Z limit inputs of the controller, and the four pin panel mounts for the proximity sensors. I decided not to wire up the proximity sensors in parallel, as they would be for the final CNC machine as I’d like to redesign and recut the plates, and would effect the wiring. To divide the 12v power for the proximity sensors I use 10k and 15k resistors, however according to voltage divider calculators online I can use different combinations. I had received some conflicting advice, and in combination is poor attention while soldering encountered problems with the signal voltage.

OpenTronic Channel: https://goo.gl/7RtiUq

Subscribe: https://goo.gl/FmlHU7

Patreon: https://www.patreon.com/EducatingSavvas

Photo Updates at Instagram: http://instagram.com/savvas_papasavva
Main Channel: http://www.youtube.com/SavvasPapasavva
Nothing happens on Twitter: http://twitter.com/savvasPapasavva
Website: http://www.miscpro.com

Видео #14 Wiring Voltage Dividers for Proximity Sensors #14 / CNC Control Box канала Educating Savvas