Clarke CL430 Lathe Tool Post Upgrade Mod
Adapting an Axminster QCTP to fit my Clarke CL430 lathe.
The tool post did fit straight on the existing stud but I had to make an adapter bush and longer stud to make it work correctly.
Also in the video a new drill chuck for the tailstock and a review of some cheap ebay cutting tools.
Видео Clarke CL430 Lathe Tool Post Upgrade Mod канала In The Shed
The tool post did fit straight on the existing stud but I had to make an adapter bush and longer stud to make it work correctly.
Also in the video a new drill chuck for the tailstock and a review of some cheap ebay cutting tools.
Видео Clarke CL430 Lathe Tool Post Upgrade Mod канала In The Shed
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Suzuki GT380 Brake caliper rebuildacewell speedo clockingSuzuki GT380 Front brake fittingHonda CB350 Part 6 Removing Alternator, Starter & Oil FilterInfrared Temperature Gauge - Can You Trust The Reading?Mini Mill DRO Upgrade part 2 - Y Axis on the Chester ChampionBoyer Bransden Electronic Ignition FaultTriumph Bonneville Project Part 6 Conical Rear WheelTriumph Bonneville Project Part 4 Front Wheel Conical Hub StripUpgrade for the Clarke CL430 CL500 Lathe - How To Make a Carriage Stop!BSA B31 Part 4 - Engine RebuildBSA A50 Part 7 Crank Sludge Trap & Timing Side BushSuzuki GT380 Front Wheel RebuildDucati Café Racer 750ss No Baffles - Insane - LoudTriumph Triple/Sprint 1050 can bus reading and sending messages - Arduino ProjectBSA A65 Lightning Clubman Top Yoke on B31 - Will it Fit?Suzuki GT380 Exhaust Part 1 - problems and fixesBSA B31 Primary Cover Build Part 2 - Completing the Boss - on the millHonda CB350 Part 23 Fitting Engine in FrameDIY Magneto Ignition Timing BuzzerBSA B31 Restoration Part 1 Engine Removal - My 2022 project begins here!