Connect Up To 992 Servos To An Arduino, Using I2C

In this tutorial, I’m going to be showing you how to connect up to 992 servos to an Arduino by using these 16 channel PCA9685 PWM drivers which are controlled over I2C. Each one of these boards can drive up to 16 servos or PWM outputs and you can chain up to 62 of them together, meaning that you could drive up to 992 servos - all controlled by two pins on a single Arduino.

Written Tutorial With Code & Circuits - https://www.the-diy-life.com/connect-up-to-992-servos-to-an-arduino-using-just-2-pins/

Components Required
Arduino Uno - https://amzn.to/3dbmMyZ
16 Channel PWM Driver - https://amzn.to/3ffVlpF
Micro Servos - https://amzn.to/3d9YAgf
5V 5A Power Supply - https://amzn.to/2ynEgJH
Ribbon Cable - https://amzn.to/3bbX78I
Female Pin Header - https://amzn.to/3b9TO1N
Male Pin Header - https://amzn.to/2VrQvML

If you've got any Tutorial requests or suggestions, let me know in the comments section below. I'm always looking for suggestions.

Видео Connect Up To 992 Servos To An Arduino, Using I2C канала Michael Klements