Replacing N54 Front + Rear Main Seals! 335i Wagon Build Pt. 8

Today, we're replacing the front and rear main seals on my N54 motor. There's a few ways to do this procedure, and while the rear main is easy to remove, I would recommend purchasing/borrowing the correct tool to replace the front seal, and it is very tightly installed from factory. While we were able to get ours out without any special tools, it was a hassle, and the results were not perfect.

Links below to all the tools/materials used in today's video. Best of luck doing this procedure yourself at home!
Note: This video description contains affiliate links. If you click on one of them and make a purchase, I may receive a commission. This occurs at no extra cost to you, but helps keep the channel going!

BMW main seal tool - https://amzn.to/3HvTWcz (affiliate)

Buy THIS to remove JUST N54 front seals - https://amzn.to/3CuXsjE (affiliate)

JB Weld High temp RTV - https://amzn.to/3Dr9Ken (affiliate)

Cobalt Drill Bits (1/16 Pilot hole size) - https://amzn.to/3FGawVB (affiliate)

BMW Recommend Sealant - https://www.fcpeuro.com/products/bmw-crankshaft-seal-replacement-kit-11117547842kt

Thanks for watching! Don't forget to check out The Bimmer Barn store to grab some merchandise, and get exclusive access to EXTRA content through our Patreon! :)

https://thebimmerbarn.com

https://patreon.com/thebimmerbarn

Видео Replacing N54 Front + Rear Main Seals! 335i Wagon Build Pt. 8 канала The Bimmer Barn