PN00409 - Makermotor
This is a brand new electric gear motor that has an extremely high torque and is speed adjustable with a PWM (Pulse Width Modulating) controller. The gear motor is measured to be 7 inch long and the motor itself has a diameter of 2.5 inches. Drive shaft is 10mm in diameter with 2 flats where flat to flat is 6mm. The shaft has a threaded end that is to fit a M6 tightening nut. Rated voltage of this gear motor is 13.5 VDC and maximum speed is 50 RPM. Rated output load is 60 watts and output toruqe at 50 RPM is 6 N-m (4.4 ft-lb). Mounting is based on M6 screw mounting. The 12V DC PWM controller features a 5 inches(12.7 cm) long connection to its potentiometer. The potentiometer has a on/off switch built-in with a knob. An overload protection is set at 10 amps of current so the controller will shut down when such a current occurs. There are connectors between the gear motor and the controller. To run the gear motor in CW rotation, please connect motor's green connector to controller's red connector and motor's red connector to controller's black connector. To run the gear motor in CCW rotation, please connect motor's green connector to controller's black connector and motor's red connector to controller's red connector. The distance of the connection wires between the motor and the controller is 10 inches(25.4 cm). The distance of the 12v connection wire is 46 in(116.8 cm) long.
Видео PN00409 - Makermotor канала Makermotor
Видео PN00409 - Makermotor канала Makermotor
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Motorized Table SawRC Lawn Mower Using Sabertooth 2X12 R/C Part 2 of 2Flag WaverPosition Control Mode for Makermotor's PN00321 Servo Motor with the PN00221 Motor DriverPN00421 Easer 25 Using 2 Motor drivers and a HW-504 Joystick to Operate XY Motions with Two Motorstrade show sign using Makermotor's PN00220 bldc gear motor.Ferris WheelPN00309 - MakermotorENPI2BSet the number of turns for Makermotor's PN00321 Servo Motor with the PN00221 Motor DriverPN00421 Easer 25 Analog Bi-directional Control using a 10k Ohm Potentiometer DemonstrationConveyor System Using Makermotor's PN00211 Variable Speed Brushless DC GearmotorMotorized BBQ Rotisseriemotorized attic ladder/hatchPN00421 Easer 25 Virtual Limit Switch by Torque (Current) Sensing DemonstrationPN00421 Easer 25 Using a HW-504 Joystick for a Single-axis Operation DemonstrationRC + PWM KITRevision on PWM12V10A with MOM-RC20171209 215058PN00113-VAR MAKERMOTOR