lever movement regulation

This video will show you how to regulate the levers on your harp by moving the lever up or down. You would only do this if using the bridge pin method (http://youtu.be/sFKYjmmjzvM) caused the string to buzz on the lever.

If you have to turn the pin so much that the string then is too close to the lever and buzzes on the lever parts:
Re-center the bridge pin approximately to where it was before it buzzed.
Then using the torx driver, loosen the screws that hold the lever onto the neck but don't remove them, just barely loosen them.
If the levered note is flat, you'll want to slide the lever down a little bit. If the levered note is sharp, you'll want to slide the lever up a little bit. Make sure you keep the lever straight up and down.
Tighten the screws just enough to hold the lever to the neck but not so much that you break the screw. Then re-regulate the harp using the other nut driver (4, 5 or 6mm) to adjust the bridge pin and regulate the note.

Check out the video on lever regulation using the bridge pin method:
http://www.youtube.com/watch?v=sFKYjmmjzvM

The tools needed to do this can be obtained from Thormahlen Harps: www.thorharp.com

Видео lever movement regulation канала thor harp