MORISEIKI lathe RESTORATION - Part 1
Teardown and get the headstock problems fixed. Next part im going to give it a really good clean up and new paint coat. rescrape compound (maybe cross slide also) dovetails.
As always, Thanks for watching guys!
Thanks for your support: https://www.patreon.com/calem21
Видео MORISEIKI lathe RESTORATION - Part 1 канала Cà Lem
As always, Thanks for watching guys!
Thanks for your support: https://www.patreon.com/calem21
Видео MORISEIKI lathe RESTORATION - Part 1 канала Cà Lem
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
DIY - A Milling VISE
Old Concrete Mixer Restoration and Modification
Turning & boring steel hollow bar on lathe for CAT 657 Scraper part | Machining
Big Lathe Restoration - Takisawa 14 X 30
Making The Hydraulic Press - DIY 20 Ton Hydraulic Shop Press
Making of face milling tool - 200mm diameter.
Surface gauge - SHOPMADE![Vise Drill Anvil [Restoration]](https://i.ytimg.com/vi/yZQQhkFjVLM/default.jpg)
Vise Drill Anvil [Restoration]
Turning large steel tube into Hydraulic cylinder barrel | Lathe machining & welding
Precision ground FLAT STONES - Home Shop
Lathe restoration
Fully Restoration Antique Diesel Engine | Restore and reuse old and rusty diesel engines
Making Cross Table![1860s Starrett Food Chopper [Restoration]](https://i.ytimg.com/vi/Tgi-ON9HxlU/default.jpg)
1860s Starrett Food Chopper [Restoration]
Turning 600mm steel ring into excavator final drive motor seal carrier | Machining & milling
The Ultimate Round Column Mill Fix
Replacing damaged hydraulic cylinder rod for Caterpillar D10 Bulldozer | Part 2
Most Destroyed Hydraulic Jack EVER ! Amazing RESTORATION
Machinists level - shopmade