Drilling Out 2002 Focus Ignition Lock

** the instructions I read said to measure 3mm down from the key slot and mark the spot. Use a 4mm drill bit to make a small pilot hole, then use a 10mm drill to drill a 35mm deep hole. I can't tell if they want you to drill out all of the "tumbler" things. If you follow those instructions, however, you WILL definitely drill all of them out. If you are able to drill a smaller hole and avoid all of the tumbler things, you will be able to put your key in. But I don't know if it will allow your key to turn.**

I ended up using a 11/32 in (~9mm) drill bit and tore all of my tumblers apart. All of the metal shavings left inside the lock made it really hard to put my key in. However, I think that if you can get all of the tumblers and the other little 1/8x1/8x5/8 piece out of the bottom, then you probably won't need the key.

Видео Drilling Out 2002 Focus Ignition Lock канала mcedsonrunescape