Bernzomatic Oxy MAP/Pro - Buy it only if you do this!!! - Oxygen tank and torch upgrade

In this video, I showed the process of upgrading the Oxygen tank for my Bernzomatic MAP/Pro Oxygen brazing torch setup.
I bought this setup initially to fix my AC system that I needed to weld a few pipes together.
There are two cons about this torch setup:
- The Oxygen tank is very small and ran out quickly. I only used it for about 10 minutes and the tank was empty.
- The knob to control the Oxygen flow is extremely sensitive. You will have to open the valve for about one and a half turn for the Oxygen starts to flow. Then you will have to turn the knob very slowly to get the flame at the level you wanted. If you over turn the Oxygen valve just a bit, the flame will be blown out.
I decided to fix both of the problems above by buying a 20CF Oxygen tank at the local welding store. THe Oxygen refill for this tank only cost $25 which is almost the same price as the original Bernzomatic Oxygen tank.
I also bought a mini Oxy/Acetylene torch so that I can control the gas flow more easily.
After a few tweaks, the new Oxy MAP/Pro torch setup works far better compare to the original one. I can control the flame very precisely.

Видео Bernzomatic Oxy MAP/Pro - Buy it only if you do this!!! - Oxygen tank and torch upgrade канала Minh's man cave