Загрузка...

Op-Amp Tutorial: Non-Inverting Amplifier with Waveform Analysis

In this video, we demonstrate the step-by-step construction and simulation of a Non-Inverting Operational Amplifier (Op-Amp) circuit using a mobile circuit simulation tool.
We begin by selecting the required components from the simulator library, including an operational amplifier, resistors, an AC voltage source, and ground. Then, we carefully wire the circuit in a non-inverting configuration, set resistor values to control the gain, and run the simulation.
Finally, we analyze the input and output waveforms using an oscilloscope to observe how the signal is amplified without phase inversion, which is a key property of a non-inverting amplifier.
This video is ideal for electronics students, beginners, and anyone learning Op-Amp fundamentals.
🔑 Key Concepts Covered
Selecting components in a mobile circuit simulator
Non-inverting Op-Amp configuration
Feedback network using resistors
Gain control using resistor values
AC signal amplification and waveform observation
Phase relationship between input and output

Where:
R1 = Resistor connected between inverting input and ground
R2 = Feedback resistor between output and inverting input

⏱️ Timestamp Captions
00:00 – Opening the component library and selecting an Operational Amplifier
00:05 – Placing the Op-Amp and adding the AC Voltage Source (V₁)
00:07 – Adding feedback resistor �
00:09 – Adding resistor � and connecting it to ground
00:13 – Connecting the non-inverting (+) input to the signal source
00:15 – Completing the feedback loop to the inverting (–) input
00:20 – Setting � to increase gain
00:25 – Adjusting AC source frequency to 1.2 kHz
00:30 – Opening the oscilloscope to view the input waveform
00:35 – Comparing input (Blue) and output (Green/Yellow) signals
00:40 – Final circuit overview and real-time waveform analysis
Copyright Disclaimer under Section 107 of the Copyright Act 1976:
This video is created for educational purposes only. Fair use is permitted for purposes such as teaching, education, research, and commentary. All content is original unless otherwise stated.
#OperationalAmplifier
#NonInvertingAmplifier
#OpAmp
#Electronics
#AnalogElectronics

Видео Op-Amp Tutorial: Non-Inverting Amplifier with Waveform Analysis канала ElectronIQ
Яндекс.Метрика
Все заметки Новая заметка Страницу в заметки
Страницу в закладки Мои закладки
На информационно-развлекательном портале SALDA.WS применяются cookie-файлы. Нажимая кнопку Принять, вы подтверждаете свое согласие на их использование.
О CookiesНапомнить позжеПринять