RV-10 Wings - 060 - Wing Wiring, Pitot tubes, AOA indicator

Patreon Campaign: https://www.patreon.com/palamedes
Builder ID Number: 41638

In this video I go through and talk to the wing wiring and how badly I want to close the wing!

I run some stuff called "Sharkbite" which is a hard plastic wire conduit that I feel is better than the black plastic grommets. I run several runs of that and run wire through it to the tip of the wings. I also rerun tubing for the pitot tube and the aoa tube.

I have to ponder where I'm going to put the heated pitot controller box in the wing, I need to make sure I put it someplace where it wont bind with the flaps/aileron rods out in that bell crank rib.

I reached out to Dynon and talked to them and the customer support was instantaneous and great! I didn't expect to send an email at 11pm on Saturday and get a response in 5 minutes.. well done guys!

Finally I affix on the back of the wing the stiffener that runs between the wing skin edge and that back spar.

This took me all darn day and I only got it done on one wing!

I'm so ready to start working on the fuselage haha.. Wings take forever.

Видео RV-10 Wings - 060 - Wing Wiring, Pitot tubes, AOA indicator канала Jason Ellis