Загрузка страницы

Arduino Indexer Part 2 ( See Metal Casting at Home Part 64 for Part 1)

This is part 2 of my Arduino indexer build. Part one was shown as https://www.youtube.com/watch?v=5GSHXC6fwq4
This will enable any number of divisions to be indexed at the touch of a button.
The electronics and Arduino sketch were devised by Gary Liming and can be seen here. http://liming.org/millindex/
Products used
Stepper motor https://goo.gl/8khVSQ
Plastic enclosure 158 x 90 x 60mm https://goo.gl/7isdfo
Arduino Uno and LCD shield https://goo.gl/5viGqE
Motor driver https://goo.gl/wYhQKo
Rocker switch https://goo.gl/WuzS5R
Push button switch https://goo.gl/5m4aGU
4 pin connector https://goo.gl/Pwm3U7

The socket part of the connector should really be on the enclosure with the plug on the motor but this is a super little connector and as the motor is only 3.2 volts there is no danger of shock
I could supply a casting for the toothed pulley if anyone wants one.

Видео Arduino Indexer Part 2 ( See Metal Casting at Home Part 64 for Part 1) канала myfordboy
Показать
Комментарии отсутствуют
Введите заголовок:

Введите адрес ссылки:

Введите адрес видео с YouTube:

Зарегистрируйтесь или войдите с
Информация о видео
22 января 2017 г. 9:30:00
00:08:56
Яндекс.Метрика