How to Build a Shed: Installing the Personal Access (PA) Door

This video demonstrates how to install a prehung exterior door or Personal Access (PA) into a shed.

Purchase this prehung door here (Perth, WA): https://store.royssteel.com.au/pre-hung-2030mm-h-x-823mm-w-pa-door-with-frame/

Remember to wear correct PPE (Personal Protective Equipment)

PART 1: Measure & Cut - 0:12
- Make sure you completely remove five ribs, so the door frame lands on pans on both sides
- Check the door size before marking and cutting
- Use an angle grinder to cut the Z's and sheeting

PART 2: Door Jambs - 0:38
- Mark the Z profile on to the door jamb
- These will form the cut lines
- Extend the the marks into lines
- Fits into the horizontal Z
- Use snips and cut along the line
- Repeatedly bend to break of offcut
- Cut out the remaining Z shape
- Test that the door jamb fits snugly in place
- Mirror the door jamb, by placing it on to the other jamb
- Mark out the profile
- Cut along the lines
- Repeatedly bend to break the offcut
- Insert the first door jamb
- Remove any tek screws that are in the way
- Insert the second door jamb

PART 3: Door Installation - 1:59
- First, hold the header flashing in the left most cut slot
- Mark the length
- From the marked point, draw cut lines around the flashing
- Cut along the line
- Repeatedly bend to break of offcut
- Insert the header flashing
- Insert the door underneath the header flashing
- Push to slot into the opening

PART 4: Tek, tek & tek - 2:46
- Tek the door jambs into place
- Tek the door frame into place
- Ensure the teks align with the sheeting teks
- Also make sure it goes into the Z and jamb behind it
- Peel of the protective plastic

PART 5: Footings - 3:33
- Tek the footing brackets on to the door jambs
- Drill holes using a hammer drill
- Use a hammer and hit the dynabolt into the hole
- Tighten the dynabolt with a spanner

PART 6: Lock - 4:01
- Use the lock as a template and drill a hole for it
- Rivet the lock into place
- Use a hammer to gently bend the four corners of the lock
- Install the handle
- Screw the handle into place
- Mark the location of the latch
- Drill a hole for the latch bolt to fit into
- Use a square filer to finish it off

PART 7: Silicone - 4:51
- Silicone the ends of the header flashing
- Using a wet finger, pat down the silicone
- Remeber to put tek screw back in

Requires:
- Tek Gun
- Angle Grinder
- Combination Square
- Door Handle
- Scissor Snips
- Rivet Gun
- Gloves
- Glasses
- Pop Rivets
- Teks
- Brackets
- Dynabolts
- Ear Plugs
- Hammer Drill
If you like these types of videos and would like to see more of them, please like/subscribe and let us know what you would like to see :)

Please let us know if you have any questions or if you have any recommendations.

--
Perth Wide Custom Steel Shed Suppliers and Builders
Website: https://royssheds.com.au/
Phone: 08 6230 2250
Online Quote: https://royssheds.com.au/request-an-online-shed-quote

---

Song: Nekzlo - Back To Summer
https://soundcloud.com/nekzlo/back-to-summer

Видео How to Build a Shed: Installing the Personal Access (PA) Door канала Roys Sheds Supplier in Perth & WA