Setting up Digitakt+Digitone combo (and 10 minutes of noodling)

I intended to make a short video on how to set up the Digitakt and Digitone, but ended up playing around for 10 minutes after I ran out of tutorial material.

With this setup, the Digitakt will act as the master: this is where you set the tempo, change patterns and press play/stop. Tracks 9-12 will mute the DN's synth tracks 1-4, respectively. Very handy if you want all the mute buttons close to each other :)

TL;DW:
1. Connect the Digitakt's (DN) output L/R into the Digitone's (DN) Input L/R
2. Connect the DT's midi out to the DN's midi in
3. Go to the DN's master page with func+LFO
4. Set L in and R in to 100 and LPAN and RPAN all the way to the left and right respectively
5. Go to Midi config - sync and make the DT send clock and program change, and set the DN to receive clock and program change
6. On the DT, go to midi config - port config and set the mute destination to int+ext
7. On the DT, go do midi config - channels and disable tracks 1-8, then set A to 1, B to 2, C to 3 and D to 4.

I hope it was helpful, and thanks for watching!

Digitakt drum loops tutorial: https://youtu.be/YSCrbF-u7gE
Part 2 of said drum tutorial: https://youtu.be/JXU8uujQr_0

Digitone bass tutorial: https://youtu.be/gfFCnILXr20

bandcamp: https://ivartryti.bandcamp.com
spotify: https://open.spotify.com/artist/4ds912FxVqFT78HZulqErS

Видео Setting up Digitakt+Digitone combo (and 10 minutes of noodling) канала Ivar Tryti