Delta Printer Homing Issue
My Delta 3D printer build, based on the prototype designed and built by Joshua Pearce, Bas Wijnen, et al at Michigan Tech. The Melzi Ardentissimo board was successfully flashed with Delta MOST firmware, with the configuration.h code adjusted and checked repeatedly. The printer interfaces with RepetierHost software, and will move manually in increments, but any attempts to make it home will cause the effector to either hit the endstops and keep going, or else travel in the other direction and crash the sides. M119 shows all three endstops work properly.
Видео Delta Printer Homing Issue канала Eric Scheie
Видео Delta Printer Homing Issue канала Eric Scheie
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Coco wants the car!Obama's Motorcade Leaves the University of MichiganPeregrine Reunion3D Clay Print Mathematical DesignRunty the Pitbull howls at Youtube dog howling videoPlecdancerBerkeley Milo RiotsThaddeus McCotter speaks at Tea PartyCoco and the BagCoco rates the Mitt Hillary Medley Ring ToneTesting a Mountain Bike TireSound SculpturePit Bull plays baseballRunty at the Los Angeles RiverDamn Helicopter!Improvised non-invasive ventilator from CPAP machine plus oxygen concentratorCoco's snow tireMicrosoft will not allow me to turn off my computer!Runty and Eric's Excellent DuetCoco rates the "Hillary Laugh" Ring Tone"Diet of Worms" (Snapping turtle gourmet)