Radial Chip Thinning - How To Program Your Milling Tool Feed Rate at a Reduced Width of Cut - DAPRA

Stop under-feeding your milling tool! Dapra provides a full-length video describing how radial (side) chip thinning works, and how to adjust feed rates for your milling tool based on the % of radial engagement (width of cut) of your milling tool. This instruction is applicable for all indexable and solid milling tools, and brings better understanding on how to get the most from your milling.

See the adjustment chart here: https://www.dapra.com/resources/milling-formulas (scroll to page bottom)
or
See an online calculator here: https://www.dapra.com/speed-feed/edge2-dss

#YourJobOurJob

Видео Radial Chip Thinning - How To Program Your Milling Tool Feed Rate at a Reduced Width of Cut - DAPRA канала Dapra Milling Solutions