I'm Building a Pick And Place!
After soldering 3,000 components by hand for the Glowtie Kickstarter, I've decided to build a pick and place! I bought an OpenBuilds Acro 55 for the X and Y axis, then I'm using a RAMPS board with Marlin Firmware for a controller. At some point, I'll integrate OpenPNP into the mix for actually telling the machine what to do. Then, I'll design custom pick and place feeder assemblies to supply components for placing. There's a lot to do!
Follow me on Instagram to stay up to date with my projects!
@stephentherobot
MUSIC
---------
Garbage - The Deli
https://soundcloud.com/the-deli/1252am
Видео I'm Building a Pick And Place! канала Stephen Hawes
Follow me on Instagram to stay up to date with my projects!
@stephentherobot
MUSIC
---------
Garbage - The Deli
https://soundcloud.com/the-deli/1252am
Видео I'm Building a Pick And Place! канала Stephen Hawes
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Pick and Place Feeder - The MechanicsTM220A table top pick and place overviewThe Index Pick and Place Can Build ItselfInside a Small Chinese Electronics Factory - From the ArchivesOpenPNP based Pick and Place robot.Homemade SMD Pick and Place Machine - complete cycleHomemade Reflow Hot Plate for SMD Soldering - 3000W3D Print your own CNC - MPCNC Lowrider2 part 1Fabriquer un CIRCUIT IMPRIME TRANSPARENT ! [ENG Sub]Getting Going with OpenPnP!Dispensing Paste With My Pick and Place!My New Pick & Place Machine [Liteplacer]Switching the Index PnP to FreeCAD!Upgrading the Pick and Place Frame!OpenPnP Pick and Place run: highlights, problems and fixesManual Pick and Place machinemanual pick and place machine for SMD componnentsPick and Place Feeder - The Electronics