How to make a Temperature, Pressure, Altitude Logger [Esp8266, WiFi, Arduino]

This tutorial shows how to make a basic logger using WiFi and Adafruit MQTT. It is based on the cheap WeMos (Esp8266) micro controller with an air pressure/temperature and an OLED shield. It is programmed with an simple Arduino sketch and put in a 3D-printed case. I also explain how the altitude is calculated from airpresure. This logger should be doable for beginners, since not much soldering is needed. Enjoy watching!

The code can be found here:
https://github.com/bitluni/Barometer
My Patreon page:
https://www.patreon.com/bitluni

Links to the parts (I get small cut at no extra cost for you):
WeMos
http://s.click.aliexpress.com/e/jUfAmUF
http://ebay.to/2skrCE1
http://amzn.to/2saaoKL

bmp180 shield
http://s.click.aliexpress.com/e/u3rVrby
http://ebay.to/2vqmK0K
http://amzn.to/2gegGFE

oled shield
http://s.click.aliexpress.com/e/n2JUnQF
http://ebay.to/2vfafce
http://amzn.to/2vyuop0

tomo m4 power pack
http://s.click.aliexpress.com/e/u3JyvJY
http://ebay.to/2xlLfgI
http://amzn.to/2gej3Iy

Arduino esp8266 support:
https://github.com/gbrault/esp8266-Arduino

Видео How to make a Temperature, Pressure, Altitude Logger [Esp8266, WiFi, Arduino] канала bitluni