4 Tire Inflation System – DIY

In this episode, I head over to my good friends garage to put together a 4 tire inflation/deflation system for airing up and down tires when out on the trail. This hose system hooks directly to your air compressor and allows you to inflate and deflate all 4 tires at simultaneously without the trouble of bending over for several minutes tending to each tire.

Here are the parts you need to build this:

50’ 3/8 air hose http://amzn.to/2tCWsek
Cut into 7 pieces
2: 12’
2: 8’
2: 3’
1: Leftover section
4: standard bore lock-on air chucks http://amzn.to/2tCZShe
3: 3/8” T hose fitting http://amzn.to/2tx0xQN
1: ¼” brass shut off ball valve http://amzn.to/2seaQ8D
1: ¼” brass barstock female T http://amzn.to/2seuP77
1: Pressure gauge with 1/4” fitting http://amzn.to/2tz3WxZ
3: 3/8” barb with ¼” female fitting http://amzn.to/2szLVvu
1: ¼ to1/8 brass reducer http://amzn.to/2szVjzj
13: ¼” to 5/8” hose clamps http://amzn.to/2txf7HZ
1 : ¼” Female NPT Plug http://amzn.to/2seaI99

Everything I'm using on my Jeep can be found here: https://www.amazon.com/shop/trailrecon

Teflon Tape
9/16th, 5/8th and 3/4 wrench
Flat Head Screw Driver
Soapy Water
Tape Measure
Cutters

Don’t want to make it yourself, buy a complete system here: http://amzn.to/2twX05a

Visit us:

Web: http://www.trailrecon.net
Facebook: https://www.facebook.com/trailrecon/
Instagram @trailrecon
Disclaimer:
TrailRecon assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Due to factors beyond the control of TrailRecon, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not TrailRecon. This video is solely for entertainment purposes only.

Видео 4 Tire Inflation System – DIY канала TrailRecon