WET Episode 3 What Are My Machine Settings
This episode of WET, I describe a process that can be used to identify what how to adjust your current/WFS and voltage to what is specified when the GMAW (MIG, Wire welder) machine has a printed dial with a scale from 1-10 or similar rather than a digital read out or true scale.
Видео WET Episode 3 What Are My Machine Settings канала David Finch
Видео WET Episode 3 What Are My Machine Settings канала David Finch
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Introduction Video
SV Seeker Welding & Shaft Placment
WET #6 Safety PPE
Bend Testing Dies Part 2 - Bottom Die Fab
Hanging Targets Single Strap System
Treadmill Shelf Part 2 The Missing Video
ALS Ice Bucket Challenge 08 26 2014
The Making of The Little Foundry
New Tooling 12.13.2014
WET #14 Initial Lathe Tooling
FABTECH 2015 Jody Weldingtipsandtricks
FABTECH 2015 Interview with Andrew Cardin
WET #13 More on Lifting Your Load
Hanging Target Stand Build
Tough Mudder Chicago 2015 GoPro 10 Walk The Plank 2.0
WET # 11 Weld Bead Placement Part 2 Groove Welds
Designing Table Grate Edge Covers
Bend Testing Dies Part 1 Concept of Build
Welder Rant
Finger Brake Stand Part 2 Design