BEST IRON and SULPHUR FILTER for Well Water

Which Iron and Sulphur Filter for Well Water is BEST for your family?
It all depends on the amount of sulphur, iron and manganese that’s in your water. If you don’t know how much you have, you can always mail us a water sample and we can test it for you.
First lets’ talk about how they work, I have more in depth videos on each one that I’ll link to in the description below, but basically:
The systems draw air through its air intake in it’s advanced electronic control valve to form an air cap within the top of the media tank. As water is sprayed through the air cap it begins oxidizing the iron and sulphur out of the water, then the media traps the precipitating iron. Every three days the air over media filter automatically backwashes all of the media and the iron, dirt and sediment are flushed from the media and into the drain. Then the air cap is rebuilt before the filter is put back into service to continue to continue to remove iron from your water.
So what’s the difference between these three? Let’s start with the FOB. They use Birm as a media which is typical successful at removing up to 4 ppm of iron from your water when the pH is over 6.8. Low, barely perceptible amounts of sulphur will be removed too but If you have significant amounts in your water, that sulphur will shorten the life of the Birm media and there will be very little sulphur removed.
Next let’s talk about the FOC, which uses catalytic or centaur carbon as the media. If you have significant sulphur and less than 1.0 ppm of iron this is a great choice at removing both in one piece of equipment. Your pH should be over 6.5 for this system to work properly.
Then we get to the newest of the triplets, the FOK. When you have up to 7 ppm of iron, up to 2 ppm of sulphur and up to 1 ppm of manganese too, as long as your manganese content isn’t over 10% of the iron content, this is your best choice Also, an FOK will work great at removing iron and sulphur when your pH is between 6.0 and 9.0 but if you want it to also remove the manganese, you need to have a pH of at least 8.0
So the bottom line is knowing your water test results will steer you to the right chemical free iron or sulphur or manganese removal system for your family.
Check out this Playlist for More info about iron and sulphur filters https://www.youtube.com/playlist?list=PLmnBltD77jBW8-AvSNoRxM5vHPjVythvB
Mail Water Samples to:
Water Store
1004 King Street
Midland, Ontario
L4R0B8 #garythewaterguy #waterfiltration

Видео BEST IRON and SULPHUR FILTER for Well Water канала Gary the Water Guy