SANCO2 GS3 45HPA Controller Programming 05202020

The SANCO2 Heat Pump has a controller that can be used to
Set the Hot Water Temperature from Heat Pump to Tank (stored water temperature)
Program in an On/Off period for the Heat Pump, this can be used in locations with Time of Use (TOU) utility rates or for homeowners/buildings with Solar PV generation so that the unit can operate only in a set period of time where electricity rates are lower or power is being generated by the solar array
Check on the last 5 error codes
Check on the operation parameters being read by the unit sensors - this provides a snap shot of the unit operation which is very useful for servicing or troubleshooting

Видео SANCO2 GS3 45HPA Controller Programming 05202020 канала SANCO2 Heat Pump Water Heaters