Custom Souvenir Coin Making Equipment Coin Mint Set with Coin Dies Cast Minting Tool Minting Machine

Buy this item via:
Etsy: https://www.etsy.com/listing/614780473
eBay: https://www.ebay.com/itm/302740903886

HOW TO ORDER:
- You can choose a diameter for coin's logos (from 1 centimeter to 3.2 centimeters).

- You can also choose (optional) metal blanks for the minting tool: brass, copper or aluminium.

- You should send high-resolution black and white logo in JPEG, PNG or a VECTOR file in PDF format via Etsy messages after purchasing.

- Black areas of your logo will be RAISED on MINTED COINS.

- Lines of a logo must not be less than 0.2 millimeter in thickness.

- ONE INCH = 25.4 mm
HOW TO USE:
A.) By using a hydraulic press (80 - 120 tons).

B.) Hand-minting:
1. Find a wooden stump made of especially hard wood (e.g. oak) with a diameter of 40-50 cm and a height of at least 50 cm. In addition, you should have a hammer weighing 6-8 kg.
2. Mark the positions of the four tool holes on a stump.
3. Drill four 5 mm holes.
4. Fasten the minting tool on the stump using four self-tapping screws.
5. Put the bottom stamp (die), a coin blank and the upper stamp to the minting tool. Rotate the minting stamps so the obverse of a coin coincides with the reverse of the coin.
6. Make a sharp strong blow with a hammer exactly in the middle of the minting tool top. A quality of coinage depends on the strength of an impact and an accuracy of hitting.
7. To get better minting results, you can make several hammer blows.
In this case, it is necessary to control the position of the coin blank relative to the bottom and the upper stamps each time.
A coin blank should be in an engagement with the stamps, in other words the imprinted logo on a coin blank should be in recesses of the stamps.
8. Coin blanks are increased in diameter after minting, and they may be stuck in the guide ring. To remove a coin, you should strike with a small hammer using an opposite side of any stamp.
SPECIFICATIONS:
- The stamping tool is hardened.

- The height of the tool with a lid is 11.95 centimeters.

- That is high-quality product made by using laser technology in Ukraine (stamps have high-resolution, high-quality and precision of lines).

The stamping tool consists of:
• Universal frame (anvil) for stamps mounting.

• One set of individual stamps (2 pieces).

Видео Custom Souvenir Coin Making Equipment Coin Mint Set with Coin Dies Cast Minting Tool Minting Machine канала SozDat