3D printer power control on Klipper: Simple!
#PSUControl #3Dprinter #Klipper
Turn on/off your printer automatically, using Klipper's MCU pin control commands. Simple and light-weight solution, that requires no extra plug-in. Raspberry Pi's GPIO were used to control relay modules.
My system:
- Creality Ender 3 Pro
- Orbiter Extruder and V6 hot end
- BTT SKR Mini E3 V2 board
- Klipper firmware hosted on Raspberry Pi
- Mainsail frontend
This video builds upon my previous project on LED lighting, which is as below:
https://youtu.be/i1FlWoHyDAw
Also, the techniques for crimp connectors are covered in this video:
https://youtu.be/kzxBVLyWrfI
Video contents:
0:00 Intro and Logo
0:52 How it works
1:49 Hardware preparation
6:37 Software configuration
11:01 Final thoughts
Видео 3D printer power control on Klipper: Simple! канала TinkerBox
Turn on/off your printer automatically, using Klipper's MCU pin control commands. Simple and light-weight solution, that requires no extra plug-in. Raspberry Pi's GPIO were used to control relay modules.
My system:
- Creality Ender 3 Pro
- Orbiter Extruder and V6 hot end
- BTT SKR Mini E3 V2 board
- Klipper firmware hosted on Raspberry Pi
- Mainsail frontend
This video builds upon my previous project on LED lighting, which is as below:
https://youtu.be/i1FlWoHyDAw
Also, the techniques for crimp connectors are covered in this video:
https://youtu.be/kzxBVLyWrfI
Video contents:
0:00 Intro and Logo
0:52 How it works
1:49 Hardware preparation
6:37 Software configuration
11:01 Final thoughts
Видео 3D printer power control on Klipper: Simple! канала TinkerBox
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Table saw pusher, parametrically designed in Fusion 360.
"Gyojasang": Korean low-rise table for living room
My first DIY woodworking bench. Small, modular and mobile. Simple and easy project.
DIY circular saw jig: Easy, simple and very very useful!
Build a heavy and sturdy desk: 2x4 Underframe for Ikea table top
Do-it-yourself powerbank for 21700 batteries
Building a time-critical application for Pi Pico with MicroPython: Good bye utime.sleep, hello IRQ!
Timestamp for data logging & NTP synchronization. MicroPython on Pico W procedures.
Building a CNC router housing for Masuter Pro, part 2/2
Parametric modeling for flexible adaption: Designing clip-on boxes and wire clips
Building a CNC router housing, part 1/2 (for Masuter Pro)
DIY Keyboard: CIY Tester68. Any good?
Build a positioning jig for your CNC machine
A Basic Fusion 360 Tutorial for Makers
Shairport Sync Airplay receiver with Raspberry Pi + PCM5102 DAC
DIY soldering fume extractor, out of cast concrete
Homemade clock using concrete casting
Concrete casting from 3D-printed molds. My journey.
Two upgrades for 3D printer's print bed: silicone bed supports and V-slot wheel replacements
Iron Stand made from cast concrete. Pinecil Iron Stand.