37 Packard Pt. 4 - Trunk Brace & Rear Panel
Brace for the trunk is fabricated and installed to help the body handle the new hinges and trunk lid. Rear body panels are cut out and planished into shape to fit the body of the car, then welded in.
Видео 37 Packard Pt. 4 - Trunk Brace & Rear Panel канала Bello's Kustoms
Видео 37 Packard Pt. 4 - Trunk Brace & Rear Panel канала Bello's Kustoms
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
37 Packard Pt. 5 - Flush Skirts
39 Lincoln Zephyr Pt. 4 - Assembling the Engine Bay
Test Driving a Slammed 1938 Ford Cabriolet Right-Hand Drive
Voodoo Larry talks about his latest, "Phantom Voodoo" at his 2021 Open House. George Barris!??
39 Chevy Pt. 1 - Independent Front Suspension and Rear End
37 Packard Pt. 3 - Trunk, Trunk Lid and Gas Tank Fabrication
Cruising the 40 Mercury
40 Mercury Pt. 1 - Bodywork, Primer and Engine Start up
Voodoo Kustoms - Voodoo Larry
37 Packard Pt. 6 - The Chop
38 Ford Cabriolet Pt. 10 - Tunnel and Front Floors
39 Lincoln Zephyr Pt. 1 - Starting the Accuair Air Ride Install
Bellos Kustoms...Ranflas Para Chukiar
37 Packard Pt. 8 - Roof Rails and Pillars
36 Ford Pt. 1 - Stuffing in a Cadillac motor and Tremec transmission
37 Packard Pt. 9 - Sail Panels
36 Ford Pt. 8 - Finishing the Floor
36 Ford Pt. 4 - Tacking Down the Roof
37 Packard Pt. 13 - Inner Structure
37 Packard Pt. 1 - Sheet Metal and Flooring