How to make a Multimeter/Voltmeter/ Series/ and Continuity Tester New DIY #community #experiment

A multimeter is a versatile tool used for measuring electrical parameters such as voltage, current, and resistance. To describe how to use a multimeter for voltage measurement, continuity testing, and in series configuration, here's a breakdown:

### 1. **Voltage Measurement (Voltmeter Function)**:
- **Setup**: To measure voltage, turn the multimeter dial to the "V" symbol. Depending on the type of voltage you are measuring (AC or DC), select the appropriate setting (usually denoted as "V~" for AC voltage and "V-" for DC voltage).
- **Connection**: Connect the black probe to the common (COM) terminal and the red probe to the terminal marked with a "V" or "Ω."
- **Procedure**:
- For DC Voltage: Place the probes across the two points of the circuit where you wish to measure the voltage. The black probe should go to the negative terminal, and the red probe to the positive terminal.
- For AC Voltage: Place the probes across the two points of the AC circuit, ensuring proper contact.
- **Reading**: The multimeter will display the voltage between the two probes on the screen.

### 2. **Continuity Testing (Audible Beep for Circuit Continuity)**:
- **Setup**: Turn the multimeter dial to the continuity mode, which is usually indicated by a diode symbol or a soundwave symbol. This mode also checks the resistance and is often used to detect if a circuit is complete (i.e., there is no break in the connection).
- **Connection**: Insert the black probe into the common terminal (COM) and the red probe into the voltage (V) or resistance (Ω) terminal.
- **Procedure**: Place the two probes on the two ends of the wire or circuit you're testing.
- **Reading**: If the circuit is complete (continuity exists), the multimeter will emit an audible beep, indicating the flow of current. If there's no beep, it means the circuit is open, or there is no continuity.

### 3. **Using Multimeter in Series for Continuity or Voltage Measurement**:
- **In Series (For Current Measurement)**: To measure current, the multimeter must be connected in series with the load or circuit. You would need to:
1. Set the multimeter dial to the current (A) setting.
2. Break the circuit where you want to measure current and place the multimeter probes in series, i.e., the current must flow through the multimeter.
3. The current value will be displayed on the screen of the multimeter.

- **For Voltage or Continuity Testing**: You do not typically connect a multimeter in series for voltage or continuity testing. The probes are placed parallel to the circuit to measure voltage or test continuity.

### Summary:
- **Voltage**: Set the multimeter to the "V" setting and measure across two points in the circuit.
- **Continuity**: Set to continuity mode (beep symbol) and place probes across the two points.
- **Series Measurement (Current)**: Break the circuit, connect the multimeter in series, and select the current (A) mode.

Always ensure the multimeter is set to the correct function before using it on an electrical circuit to avoid damaging the multimeter or the circuit.#voltmeter #series #continuitytester #multimeter #Pancil #TechTutorials #Tips.#Community #ScienceExplain #TechInnovation #TechInsights #TechTalks #TechForBeginners #TechGuru #TechNewsUpdate #ITProTips #LearnTech #TechExplainers #TechWorldhow #kts #KTS #kuchtechnicalsekho #kuch_technical_sekho #KUCHTECHNICALSEKHO#KUCH_TECHNICAL_SEKHO

Видео How to make a Multimeter/Voltmeter/ Series/ and Continuity Tester New DIY #community #experiment канала Kuch Technical Sekho