LINE 6 HELIX TIPS AND TRICKS FOR LIVE/GIG USE WITH MY IMPULSE RESPONSE FREE

My custom Impulse response (created with mixir3), the IR are RAW:
https://drive.google.com/drive/folders/1r21CJVihOdhjN-Sse6m8wOfSLbxF26-b?usp=sharing
https://paypal.me/ircustommix?locale.x=it_IT
email: gabryga76@libero.it
TO LISTEN THE HELIX WITH THE BAND:
3:04 in rehearsal studio
3:28 live in a pub with bad acoustics
backing track(blues in LA7)for make guitar patch ,at loud volume (no reverb in the backing track):
https://youtu.be/W5ycvz-9oMQ

,In this video my tips and tricks for LIVE USE, direct to PA system:
1)play in mono (no stereo effects)
2)use dark Impulse response with low cut 160-200hz and hicut 5- 6,5 khz(use cab eq)
3)use a block eq after the cab or at the end of the chain,before the compressor, with low cut 80-100hz and hicut 10-11 khz
4)remove resonance and bad frequencies with a parametric eq
5)use a LA COMP at the end of the chain
6)turn down the amp volume for avoid digital clipping
7)turn up the 'mid' in the amp
8)global settings: PAD ON and xlr output MIC
9)for 'leads' boost the volume output 7 db AND/OR MIDS AND PRESENCE
10)choose two amps, one for distorted sounds and one for clean sounds and always keep those, adding or changing delays and modulations, each amp behaves differently in the 'mix'... if you change a simulation every song you just make a big mess
11) use the global eq for cut the bass (in little pub),i use low cut 100- 260hz with big woofer at loud volume
12) make the patch/prests at loud volume with the band or with a backing track(NO WITH HEADPHONES)
13)NEVER USE REVERBS!!!
14)for 'clarity' turn down HUM,RIPPLE and Resonance, and turn up bias (from 5 to 6.5)
15) turn down , with a parametric eq (Q=10 ) the 4khz frequencies (6db)
my setup:
Line 6 Helix LT with boost HT in front/mod Rex effects send return
stratocaster cloe guitar with dimarzio injector.

Видео LINE 6 HELIX TIPS AND TRICKS FOR LIVE/GIG USE WITH MY IMPULSE RESPONSE FREE канала Gabriele striuli